The chart below is only a guide. In order to assure correct sensor selection for your application, we recommend contacting us directly.Select the Proper Sensor from the Table
- Locate the pin size that will be used and match it to the location on the part (Near the End of Fill or Near the Gate).
- The intersection of the row and column is the sensor to use (Lynx Strain Gage or Piezo based on the mold application).
|Normal Pressure, (e.g. Typical Molds, End of Cavity)
5000 PSI / 350 Bar / 35 MPa
|High Pressure (e.g. Thin Wall, Post Gate)
10,000 PSI / 700 Bar / 70 MPa